Any Chicago Area users???

[scr2000]

Hey everyone. Just seeing if there are any other people out there in my neck of the woods. Perhaps start a meet-up group to talk shop, discuss tips, etc...
Sean

[pine acres woodshop]

where at in Chicago?
Mark

[daveh226]

From the far south subs-

[Icutone2]

From Aurora how close are you?

[scr2000]

Well, I live on the semi-northside of Chicago, Bucktown neighborhood. I'm right off the Kennedy near Webster and Damen.

[cnsranch]

I didn't think Bears fans knew how to use computers :p

[LittleRedWoodshop]

The CNC Art Guild of America page or www.CncArtGuild.com (http://cncartguild.com/) was set up to help us find each other. If you take the time to sign-up it makes this process much easier. Also helps us find those people in a given area that are active users of the CarveWright.

Check out this page to find people in your area http://cncartguild.com/16501.html

[SeaCapt97]

Orland Hills is a far south suburb of Chicago approximately 2 miles North of I-80 and LaGrange Road (Rt. 45)

Bill

[lostinthefrost]

I am down in bloomington. most people think it's "southern Illinois" since it's below 80.