lovejoys
01-16-2009, 09:32 AM
Hello to all
I broke two Z tuck this week it look to me like it is hitting the bit plate to hard is there a way to stop it from hitting it so hard
will calibrating help with this ?
is there another way
any help pleases
Yes I have the washer in place botom right any other ideas
I broke two Z tuck this week it look to me like it is hitting the bit plate to hard is there a way to stop it from hitting it so hard
will calibrating help with this ?
is there another way
any help pleases
Yes I have the washer in place botom right any other ideas