When making the Classy Christmas Wreath.....

[jonm3]

When making the Classy Christmas Wreath would it be better to use the scanning slide so that you will protect your belts? Where the bits don't cut into the belts.

Any idea's about the Classy Christmas Wreath on how it came out? any hints?

Oh, I have my Carve Wright Machine up and running. There was no BB's in the QC, just that the bit adparter allen screw came out about 2 weeks ago when all this started that I had to contact Carve Wright. I did my first carving since being down, but with the cold weather that I have, I have held off of even thinking about my Carver Wright. Few days I had 10 or 20 degrees in Virignia.
But I did a sign today for someone, I had to resize the photo to be small enough to up load it. Thanks.

[Pratyeka]

Just a remark, it's impossible for the bit to carve into the belt.

[Amonaug]

The bits will always stay over the slot between the belts, it's the board that will move back and forth in what's called the X-direction so the bits will never come near the belts.

[jonm3]

Thanks, it will be one project that I will make. Plus others too.