- Auto-Jig error message when uploading to card and not able to add Tabs
- Universal sled
- Having trouble adding texture
- Controller Replacement? available?
- Check Board Sensor Error / FFC cable fatigue failure
- Keyhole bit stop collar
- Tracking Roller error
- once again tracking roller error
- When Cut motor starts goes back to main menu
- at a loss y axis stall
- USA FLAG free download
- Z-Axis Off?
- Depth of carve problem
- machine head not going down
- Start Problem
- Y Axis jogs in Carving Project
- cut path off center
- Install new Truck Bearings?
- Problem after Problem after very disappointed
- cut motor seems like it is locked up
- lines in carving
- Replaced my truck bearings, now get Y axis stall E05-0314
- Bit won't touch bit plate
- Tracking error when loading board FYI
- Bad cut motor
- locking handle
- I am a bit puzzled, why is quality setting ignored?
- New Z axis stall cause