Activity Stream

The machine is supposed to bob the bit into the one of the holes in the side of the carrier; not stall into the top of the side. If you use the...

I have had a few successful carves with the UCB and really am pleased with it. BUT....I have brain freeze when I try to do a cut out carve, I can't...

No worries. Hope your grandson loves the carving.

Well, this is quite the old thread but I am in Kaufman county.

THANK YOU so very much Oscar. My grandson will love it. I make him an ornament every year and this was this year"s request. Please email with an...

Go in Designer to EDIT > PREFERENCES. Kick your Rendering Cache up to 512. It won't stop the ball of death, but it will minimize the spin time.

looks awesome!

I'll do that, thanks.

Not familiar with the character but found a picture on the web which I ran through Shadermap. It was still a little rough so cleaned it up a bit more...

I am using blender 3d. The newest version is a beast in a good way.

I have a similar issue, I am running Mac os 10.14.6 Mojave. Most of my design is with vectors, it is almost impossible to insert a vertex where I...

There are known issues with the Mac, your best bet is to call CarveWright to get the latest updates with what is going on and support for your issues.

Are your drawings made with sketchup?

Belated thanks!

I had a bunch of honey do's today so didn't get a chance to start. Probably get it done in the next few days. Hope to see a few examples from you...

This was a good exercise to go back and practice this stuff. Obviously there are different roads to get to the same destination. I learned when...

Ok, gotcha.

lol.....I just meant that if I'm doing a quick carve I'll gamble and go for the bare minimum least number of tabs I think I can sneak by with, but...

If you select only the upper-level Groups and patterns, and not the second level and beyond, then hit Group, I think you would get what you want.

The number of tabs shouldn't affect carve time much. Why do you think so?

I really like that design a lot, I'm looking forward to seeing the end result too.

Thanks everyone! Painting a carving for me is almost like a coloring book, because I have lines to follow. I couldn't paint that on just a...

Very nice project!! I like the easy fast design elements! Looking forward to seeing the finished product! Your illustrations are Great!

Yes you can raise the head up. Since it stalled the machine the project has stopped so you can not resume at the place it stopped. Depending on...

Can I raise the head up? The bit is in the Board so I can’t move the board. Will I be able to resume carving or have I lost this project?

Look to see if the board is jammed up in the machine. Verify that the sliding plate is not pushed up tight against the board preventing it from...