if i cut .625 is it going to try to cut this in one path i had depth set for .125 it is cutting .25
if i cut .625 is it going to try to cut this in one path i had depth set for .125 it is cutting .25
jeff
DO NOT FEED ! THE DRAGON
Thanks!
Some guys are removing 1.130 and then installing 1.126.
after rolling back, look in your firmware directory.. save the 1.126 firmware but with a new name.
re install 1.130 and you can load the two versions of the firmware on to your memory card when needed.
LG
problem solved i had to get a new module and now it does not ask to jog to position or cut so deep in one pass
jeff
DO NOT FEED ! THE DRAGON
RIGHT ON .. And then some!
Alright guys, a few of these posts are going a bit too far and have been removed. If you would like to offer constructive criticism, great, this is a good place to do that. If you just want to throw a temper tantrum, this is not the place.
I would say why not! From folks that have the machine!
I have many problems with mine BUT like a wife I had... I love it!