recess newbe question?

[Jim_colo]

Help newbe question?

I found the recess_for_golf_ball some were on the fourm. How was it done?
This is a 2nd project test as I play with the software.

I can find were it was been done but not how!

Thank you…

[DocWheeler]

Jim,

Here you go.

[Kenm810]

Try starting with a circle or square, then turn it into a carved region ,
next use the surface select. set the depth you want and the height you need,
then finish with the draft and feather setting to suit you.

[ChrisAlb]

And then of course when you start combining them, the fun really starts...LOL

[Jim_colo]

Try starting with a circle or square, then turn it into a carved region ,
next use the surface select. set the depth you want and the height you need,
then finish with the draft and feather setting to suit you.

I tried every thing I can think of still not able to make it round

[Kenm810]

Check the measurements
1.5" Dia. x .75 Rad. x 999 Hieght

[Jim_colo]

Check the measurements
1.5" Dia. x .75 Rad. x 999 Hieght

I see where Mr. Michael T used ArtCAM software to make the Recess_for_Golf_Ball.ptn

Can this be done with out the ArtCam softwear?

Sorry for danging this question on.

Thank You all for you time