When craving say a 6" square pocket region 1/2" deep, how do I leave a 2" square cube in the center of the crave? I should know the answer but I don't.
When craving say a 6" square pocket region 1/2" deep, how do I leave a 2" square cube in the center of the crave? I should know the answer but I don't.
Probably different ways but I would create the 6" carve region 1/2 " deep, center both ways. Then create a second carve region in the center 2" with a depth of .001 and center both ways. Should give you the uncarved block in the center. Hope this is what you're looking for, if not let us know.