Originally Posted by
flyingemt
ALL,
This is a new one for me....
Just cleaned the rails and the nuts due to crank down binding. Machine is reassembled, went to start a new project, and when the "Stay Under Rollers" pops up, I cannot get 1 or 2 to respond. I tested from the "home" bootup screen, no problem. Both function appropriately.
Any ideas??
Mike
Do the down / up arrows and enter key work? (Workaround...not sure about keypad, unless not plugged in all of the way or tear in cable.)
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!