Deep lines carved

[Sconi]

when I carve I often get several lines deeper than the rest of the carve, usually near the beginning but they can show up anywhere, here are three photos of what I'm talking about. These were done on the universal carrier base but they happen without using it as well.

My bits are sharp, the mpc's - one from Cartwright by Michael Tyler the other is one I did myself so I don't think it's the pattern.

Any thoughts?

Thanks

mjc

[Sconi]

I'm planing to carve just a square no graphics to see if it does it on that as well, just as a test....

[fwharris]

I would look for a bad Z belt or gear, loose bolt in the Z gear box, dirty compacted compression roller ends.

[mtylerfl]

Are you following the "7-inch Rule"? If the board is not captive under both rollers at all times during a carve, it can "tip" and create lines in your carving. The longer the board, the more likely a board "tip" will occur if not held flat/captive under both rollers during the entire carving process.

If you are following the "7-inch Rule", then it may be a mechanical issue as Floyd suggested.

[bergerud]

I would have to guess lumpy z rollers. Either adjusted too tight, sawdust in them, or compressed sawdust between them and the rails.

[Digitalwoodshop]

I am with FW on this one.... A FLAT SPOT in one of your RUBBER COMPRESSION ROLLERS from leaving the machine cranked down on a board overnight....

The Flat spot lets the board RISE UP into the BIT making the lines....

AL

[rmock]

I have had this happen recently, I had a loose z truck and some wear on the z rails. I removed the truck and turned the rails then made sure the truck was tight but not over tight.

[saylesj]

same sort of question

I am getting undesired lines/ drag marks / scratches in the bottom of my carved region, They're only as wide as the bit being used different from the roller marks you get when the board is not under the roller I read somewhere online that it could possibly be dust in the encoder can somebody please describe to me where that is located on the machine itself? I have removed the top and cleaned the pulley areas etc. This is occurring with both of my bits as well. in the sensor check menu "z" seems to be working.... Do you have to replace the whole motor to replace the encoder any help would be greatly appreciated

[bergerud]

Just take the back cover off of the z motor. Three screws. Catch the two nuts on the bottom ones.

Your problem may not be the encoder but it does not hurt to have a look.

[saylesj]

Does the cover kind of look like a heat sink? Or is there another cover