Dan you don't know how long Iv'e tried to make a pattern on the import image file it was never that important so just gave up.. when it don't show up like the lower loop you select .0 carve region is that the general rule.
Dan you don't know how long Iv'e tried to make a pattern on the import image file it was never that important so just gave up.. when it don't show up like the lower loop you select .0 carve region is that the general rule.
Last edited by aokweld101; 07-21-2015 at 02:35 PM.
The lower loop was not connected. It could not be made into a carve region. That was just a little detail. The 0.00 carve region was so that that loop would be a hole when later inverted.
I wanted to show you how my pattern worked out, Thank you again Dan
Nice. (bit optimization best on the CJ?)
No... but I will... thanks..