attached is some pictures of the cutpath not going thru the project board.
The strange part is I used this same project for a demo yesterday. I when thru the measuring of the sled,
checking the 3 bits, when the cutting bit was installed, it when thru it's regular process and then it asked what was the thickness
of the project and I gave it .75, then it ask for the carving bit and starting carving. a couple minutes into the carving
I stop the it .
This morning I used the same sled with the board still in the it and when it ask for cutting bit it decided the board too thick
and gave me the options of abort or continue.
This is strange, in the last 3 projects I did , was the "Gone Fishing" projects, it did the same thing, the first time was find and 2nd and 3rd "board too thick"
I'm not sue what's going on here. check out the pic.s