Henry,what gear might you be refering to?
Henry,what gear might you be refering to?
Like I said, I have hit the end of my list as things to do I'm going back out in the shop tear it down and inspect the two remaining things which is the belt and tention pully.
Last edited by aokweld101; 03-04-2015 at 08:03 AM.
I think Chris may be right. The circuit board that you plug the y motor into could have gotten damaged. It makes sense. It seems that the motor current feedback signal is not getting to the computer. I would take a really close look at it and all the connections on it.
Well Dan, it just so happens I have that board I will replace it and see what happens. I'll have a new machine before long....lol
I got it running again... changed out the last two things ... the circuit board and the tentioning rollor... I have a whole new y systen instaled... my guess it was the circuit board. lol
Well, good you are up and running and good to note now a reason why the carriage stalls into the wall.
AOKWELD101<<<<<<< Putting this expeince in the memory banks... Thank you gentelmen for the help...