Question, what is the smallest diameter you can carve down to with the Rotary Jig?
Thanks
Jim
Question, what is the smallest diameter you can carve down to with the Rotary Jig?
Thanks
Jim
" The Hurdier I Go, The Behinder I Get"
I have done walking canes that were 1 inch across
Leo Davenport
Enjoy Life Carve Something everyday
I just test carved a piece .750" deep. I don't recomend doing it, but I wanted to know how it would perform. The wood was flexing a lot as the bit made the cuts on the last 1/4" of the circumference.
I think if one had a short dowel, and used "Ask Buds" third rail, it would be fine. But then again, I'm not recomending it.
(it's not recomended that you drive a car over the speed limit, but folks do it all the time) just saying.......
My Website: www.edscustomcarved.com
Patterns or projects made, and uploaded by me, are not to be sold on E-Bay, EVER !.
Thank You....