OK- I did the entire test again:
- I reformatted the memory card.
- Made a new series of Cut Paths & Routes in Designer 1.186
- Moved the file to the memory card but selected firmware 1.179 (supplied by bergerud) along with it
- Verified on the Options menu that it was running v 1.179
- Ran the file and the Cut Paths were rough and jerky while cutting. The Routes were smooth.
Bergerud, In your post below, are you saying that you created the project in Designer 1.179 and Designer 1.186? Can't tell if you made the file again using Designer 1.186 and then ran it using firmware 1.179. If your project was made with Designer 1.179, then the bug must be in Designer 1.186.
- I requested from Carveright to get a copy of Designer 1.179 (phone call and email today). Have not heard back yet.
- Does anyone have Designer 1.179 they can email?
Thanks, John
Ok, that is strange. Did you upload the project after you changed the firmware or did you just change the firmware?
I just used the firmware from 1.179. I used Designer 1.186 to upload the project.
Edit: I originally used both Designer 1.179 and its firmware but I got the same result just using the firmware.