This is the first time i have come across this problem or so i think. I keep getting clear board sensor message but when I use function 0 then 7 to check system the board sensor reads , any ideas?
This is the first time i have come across this problem or so i think. I keep getting clear board sensor message but when I use function 0 then 7 to check system the board sensor reads , any ideas?
Are you carving a dark color wood?
nope regular pine
and I did try the tape trick still same error
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Remember the test is to put a piece of white copy paper on the board and crank it down. The reading should be about 156 for a perfect reading.... 90 is usually a dirty lens either inside or outside.
The paper makes for a Standard... My paper is the same as your paper... Boards not so much...
AND.... The FSC Cable has the Board Sensor Signal on it... So a BAD FSC Cable can cause this.... The Trick is to get the 156 reading THEN put your hand on the cable and FLEX it CAREFULLY and SLOWLEY... IF the cable has a broken Wire it will show up...
AL
Last edited by Digitalwoodshop; 11-18-2012 at 07:04 PM.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Which strand in the cable carries the sensor signal?
On my machine, I have never gotten anything over a 70 in all the times I've checked the sensor readings. I was still able to get it to work, with tape and paper masking, but now just getting zeroes on sensor check.
Last edited by eastcutty; 12-05-2012 at 11:21 PM.