If u guys have a tapered 1/8" carving bit, I don't know where it came from. I've been here since beginning of '08 and have never heard of one.
Sent from my iPhone using Tapatalk
If u guys have a tapered 1/8" carving bit, I don't know where it came from. I've been here since beginning of '08 and have never heard of one.
Sent from my iPhone using Tapatalk
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Here is where I got mine - http://www.soigeneris.com/PreciseBit...s-details.aspx
I have used it to carve preminum pine and it has done an excellent job.
Then I guess it's just a matter of...since we don't sell it, the machine (or firmware to be more accurate) is not set up for it.
I'll ask if they have tested it and why not using it.
Sent from my iPhone using Tapatalk
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Sure would be a plus for the machine.
Morton
Review post #9.
AskBud
http://forum.carvewright.com/showthr...654#post177654
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
I been using the 3/16" ball and 3/16" mill bit to carve tops the results in the raster speed department is worth the setup.