I cut wide board all the time and nearly always have to enter the thickness manually. Today, I go to enter the thickness, as usual, and every time I enter the number and hit enter the machine just goes back to "enter board thickness 0". It seems that it will not accept any number to proceed. Ideas ???
Board size is 14"x60" ...yes, I have outfeed rollers.
I have recalibrated the depth setting.
Triple checked the designer program, cuts, bits, depth, etc.
Card has been reformatted & reloaded. Machine unplugged & rebooted. Board re-inserted.
Everything is fully cleaned.
Width & length measure accurately.
HELP !!!
Brad