hi
i tried to look through the archives but all my search came up with nothing or too small of words or something i was doing wrong. Thanks
Is there any way to fix a broken shaft on a scanning probe. i think i tightened down the rock chuck too much and when it hit the side of the sled it broke i think but it is now broken off about 1/16" above top is there any way to fix. I think i could super glue a 1/2 to 1/4" rock chuck adapter on to it but not sure how much that would be compared to a replacement chuck if you can get one?
Any Ideas.
I have only scanned one thing so i am not much good at scanning. I think my sled side rails were too high for how short the part was. I set the depth on to the top of the part and then told it to go 1" offset to that thinking it would use the top as the height and then scan 1" down but i forgot about the two side rails being higher even though i didn't put the side into my scanning area, could that of been what broke it.
Thanks for the help
Tim