Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.
To order the "Made in USA" Rock Chuck, and other custom tools and accessories I make for your CarveWright, see my website by clicking here -> http://www.cw-parts.com
See a quick video of the new Rock Chuck in action here!
Read up on QC Removal for stubborn chucks here
See the Rock install video here
You can also visit here for discussion content.
Email me by clicking here
Thanks Ron, I didn't understand the comment. So if Their new chuck goes out you have to replace the whole z-truck?
To order the "Made in USA" Rock Chuck, and other custom tools and accessories I make for your CarveWright, see my website by clicking here -> http://www.cw-parts.com
See a quick video of the new Rock Chuck in action here!
Read up on QC Removal for stubborn chucks here
See the Rock install video here
You can also visit here for discussion content.
Email me by clicking here
I have the Rock chuck, and it is the best money I ever spent on this machine. If my z-truck was to go out, I wonder if I would be able to get a replacement z-truck that would work with the Rock Chuck?
To order the "Made in USA" Rock Chuck, and other custom tools and accessories I make for your CarveWright, see my website by clicking here -> http://www.cw-parts.com
See a quick video of the new Rock Chuck in action here!
Read up on QC Removal for stubborn chucks here
See the Rock install video here
You can also visit here for discussion content.
Email me by clicking here
My understanding is that you send them your old z truck after they give you the new one with the spindle for the core charge. Also that the new z truck and spindle are all new materials.
So I figure they are going to be swimming in old z trucks. Not very conservation or economically friendly, but I have seen stranger things.