Hey guys and gals,

I'm in a really bad way today, I recently sent my machine to carvewright to be repaired and got it back about 2-1/2 weeks ago and went to use it for the first time today (Sunday 2/25 ) and slid the card into the slot and picked my project etc.. My problem is this every time I try to go through the menu to get the project started I keep getting the clean board sensor error and after several tries it will not go past the error message!!
I'm trying to keep calm but I spent a very good sum to get this thing going again and think I shouldn't have to work on this immediately after getting it back, is there something I'm doing wrong? when it asks if I want to stay under the rollers I press yes and that's as far as I can get it to go.

Any suggestions will be very much appreciated.

Thanks in advance, Chuck.