-
Big problem here
I only have time to carve in the winter months and am getting a late start. I sent in my machine last summer for LHR to do a major service. Repair and replace anything they see that seems like a good idea as well as all available upgrades.
When I got it back, I did one small project as a test and everything seemed fine. Now, I am ready to make some signs and have a big problem.
Everything starts up OK and it starts carving the sign and then I can hear it start to struggle to spin and then it slows down and stops spinning. This happens after a couple minutes. The machine continues to go back and forth as if it is carving, but whatever bit is in is stationary. When I open the lid, I try to spin it by hand to see if anything is catching or binding and it seems to spin freely.
Any tips on how to proceed would be greatly appreciated.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules