Results 1 to 10 of 34

Thread: Axis stall - Z Axis stall E06-0313 - Z and Cut motor tests just loop

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #25
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,314

    Default

    You might can use it to troubleshoot your controller. Hopefully, there was not a bad cable or bad board that would mess up your other controller.

    My suggestion is to send it in for testing and use that as $100 towards a new one, if necessary. Send Rebate Form.
    Last edited by lynnfrwd; 03-27-2014 at 03:49 PM.
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •