So, I had an idea...I took a 2x4 as my board design, then double it, so it was, effectively, 4x4. (in real world, essentially, gluing two 2x4s together). I designed a pattern on a rounded dome, then copied all and pasted on the reverse side. Is there anyway to place it on the Side side? What I'm trying to do is put the same pattern on all 4 sides of my 4x4 using the software.

Yep, I'm aware that so long as I leave edges, I can just run the pattern on both sides, then rotate 45 degrees. I'm looking to make sure it isn't going to cut through first.

Thanks in advance for the help