This Y stuff is why I'm grumpy. After tearing my machine down three times I still can't carve - sort-of.
I put in a test piece that was to have two 1/4" regions carved in it. Then the 1/8" cutting bit was to give it straight walls.
I saw that the regions were AGAIN starting in the wrong Y position, but I let it carve since my test was to see
if the shallow region matched the cutout of the piece that was to be glued above it. When it came time to change
to the 1/8" bit, I got that Y-error as the truck slammed to the keyboard side. It does not hold its Y position!
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi