1.132 to the rescue problem solved thanks
1.132 to the rescue problem solved thanks
"Our principles are the springs of our actions. Our actions, the springs of our happiness or misery. Too much care, therefore, cannot be taken in forming our principles." Red Skelton
I have 1.132 and previous versions back to 1.19 on standby
Please support Cystic Fibrosis
Last edited by Bubbabear; 01-14-2009 at 01:51 PM.
"Our principles are the springs of our actions. Our actions, the springs of our happiness or misery. Too much care, therefore, cannot be taken in forming our principles." Red Skelton
I have 1.132 and previous versions back to 1.19 on standby
Please support Cystic Fibrosis
OK, so we have a report that 'Cut to Size' does not respect the Max_Depth_Per_Pass programmed into the machine. Has this been resolved in the recent 1.132 release. If not I'll add it to the bug squashing thread.
Happy carving , Jeff Birt
Check out www.soigeneris.com for CarveWright Accesories.
Home of the 'Carving in the Dark' back lit LCD kit!
Jeff the 1.132 has cut to depth where you can adjust it 0 5 6 on the keypad
Last edited by Bubbabear; 01-14-2009 at 02:06 PM.
"Our principles are the springs of our actions. Our actions, the springs of our happiness or misery. Too much care, therefore, cannot be taken in forming our principles." Red Skelton
I have 1.132 and previous versions back to 1.19 on standby
Please support Cystic Fibrosis
Good to know.. I would like to change calibrate off sets so the first cut is smaller 2 when using the 3/8 bit.
LG
LG it will go 3/4 3/8 or 1/4
"Our principles are the springs of our actions. Our actions, the springs of our happiness or misery. Too much care, therefore, cannot be taken in forming our principles." Red Skelton
I have 1.132 and previous versions back to 1.19 on standby
Please support Cystic Fibrosis