Is there some way to restart a project after the power is lost and the machine turns off? when I started it back up I had to begin from the beginning and had know idea how to do anything but start over.
Is there some way to restart a project after the power is lost and the machine turns off? when I started it back up I had to begin from the beginning and had know idea how to do anything but start over.
Take a look at the early posts in this thread. if you still ahve questions, let us know.
http://forum.carvewright.com/showthr...on+zero&page=4
Doug Fletcher
also you might look at this thread, hope it's not the same on.
http://forum.carvewright.com/showthr...ght=restarting
"Blessed are the cracked, for they shall let in the light."
~Groucho Marx~
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com