Creating Lettered Sign

[edva53]

I am a new user. I'm trying to create an interior sign for our church that says "Welcome Center". I've attached a picture of some existing signs that I'm trying to copy the lettering style. Note that the letters are connected as in cursive writing. I've created what I need in the design software with one exception--I can't seem to connect the letters so that they will "flow" together" and be cut out as two separate words rather than individual letters. I've also attached a copy of what I've created in the the design software. Any help is greatly appreciated.

[DrBob]

Hi edva53
Will this help?
You can also look for a font on the internet that you want.

[AskBud]

See if you have Edwardian Script on you list of Fonts.
AskBud

[sweliver]

Have you tried to decrease the letter spacing when in the "edit text" function? Changing from +/- zero may help, may not.

Have you carved it yet? I've had consecutive carves of the same project come out with noticeable difference with only minor depth and spacing changes.

sw

[edva53]

Have you tried to decrease the letter spacing when in the "edit text" function? Changing from +/- zero may help, may not.

Have you carved it yet? I've had consecutive carves of the same project come out with noticeable difference with only minor depth and spacing changes.

sw

I haven't carved it yet. Decreasing the distance helps, but creates no connection between the "W" and the "e" unless the other letters are so close they're literally overlapping. Also creates 2 points of connection between some of the letters rather than just one connection.

I think I should try using the drawing tool to create a connection between each of the leters and then try a test carve.

[edva53]

See if you have Edwardian Script on you list of Fonts.
AskBud

Thanks for the suggestion. Problem with that is I'm trying to match the font of the existing signs in the jpg image and the font that matches that is the Monotype Corsiva.

I think I may need to use the drawing tool to create a connection between the letters much.

[edva53]

Hi edva53
Will this help?
You can also look for a font on the internet that you want.

Thanks. The font I'm using (Monotype Corsiva) matches the existing signs in the jpg pictures. I need to create a connection between the letters. Suspect I may need to use the drawing tool and draw the connection between letters.

[AskBud]

I think that with any Script, the capital letters are not connected to the lower case letters as a general rule.
AskBud

[John]

If I remember correctly Jon Jantz had some info. on this on his site, allcw.com He uses coreldraw and welds the letters together and then uses the trace function in the CW software package.

After getting the design done, this is going to be a big project of the CW. At .75" depth you looking at close to 10 hours carve time! A paper pattern and a scroll saw would be a good second choice.

[sweliver]

Lucida Handwriting...you may have to adjust board/font sizes but the text comes out connected on my screen. Until you carve you'll never know.

sw