Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Thanks Al! Your explanations help a lot.
I took the Y Truck off... Even snapped a screw as seen in the pictures.... But I wondered if I could do then butt Floss Trick... un hook the board sensor. Un hook the top plug. TUG the wire UP to dislodge the pinch. Then pull down and up, seeing if you feel it free.... Worth a try....
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Air shipment of parts should be here this week. Hopefully, customs won't hold them up.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Just as I took apart the old sensor and cleaned it and glued it back together, I got an email from Carvewright saying my order has shipped. Haha, go figure. i'm just going to wait the week till the part comes in to get back to carving.