Does anyone know what err E06 0313 is? need help
Does anyone know what err E06 0313 is? need help
At what part of the operation did you get the error? That is more telling than the code.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Did your bit drill a hole in the brass wheel holder? As cut motor ages it spins longer on it's bit check.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
when I try to start a carving or test the Z I getE06-0313. first it said clean board sensor after cleaning the sensor tried to start carving and got the error and also get the same error when I try to test the Z
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Thanks to everyone for the help with my Z motor stall and carving thru board. I found the problem it was the computer tape wires that goes to the Z motor.
Thanks again for the help and Happy holidays to all.
Davidbf