-
What I have been up to
For the last three years, I have had no time for carving or even working within my shop. I, with a little help have been building a barn (maybe even a new shop inside). It is 30'x50' with 12' sides and 21' to the peak. Basically I have had another person helping me up until the siding went on. Then it has all been myself painting, building the sliding doors, hanging them, putting on trim and just last week I installed the side door. This has taken up all my spare time (well other than when my grandson spends the weekend with me)
Over the next few post I will show the progress. This spring I will finish the bottoms sealing the barn, and I hope to trench and install the electric service.
Last edited by eelamb; 02-27-2017 at 05:41 PM.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules