I am pretty sure I have split a project across multiple boards before, but I cannot figure out why the "finish' button is grayed out. Any ideas on the step I missed?? I have saved it.
I am pretty sure I have split a project across multiple boards before, but I cannot figure out why the "finish' button is grayed out. Any ideas on the step I missed?? I have saved it.
I have not tried to split a DXF across boards before, but , it seems to me that each spline object must be on its own board. Trying to have the importer break the curves may be expecting too much.
That certainly makes sense. I will try one board and shifting. Thanks!
This might help you out.. http://www.carvewright.com/up-cycle-an-old-cedar-fence/
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
I just went looking for the conference info, I knew that Joe had done the fence there. Eureka! pesky split across boards button on the "shapes" tab!
Cool. I love to find out new things. I did not know about that one.