I know there is a way to do this, I think I have seen it before, but I can't find it.
I have a project that has a pattern on the front of the board and recessed rectangles on the back to be used as mortises. I need the 1/16 for the pattern but wanted to use the 3/16 for the pockets so the would have a straight edge and would carve faster. I set the rectangles as carved regions 1/4 deep from the tool bar.
I cannot set a bit for these separately the way I am doing it and have to set the bit for both under board settings. What am I doing wrong?
Thanks
Sent from my iPad using Tapatalk