-
When do I use the 1/32 Ball Noise bit
I am working on an Eagle pattern that is cut thru in 1/2" thick board. Can I get greater details using the 1/32" Ball Noise bit or should I use the 1/16" bit?
-
I just did an urn with Praying Hands and roses on the front. I do this in 2 passes. First pass with everything but the praying hands, roses and the inset where the reside hidden. I do this with the 1/32 bit on optimal to get
t detain on the very small roses. Then without removing the piece I run pass 2 with the hidden parts switched and there is a zero depth carved area over the hands and roses. I do this with the 1/16 bit on best. Ask Bud and I had a long discussion on how to put a carved out area in a shaped carved area. This is my solution with a couple advantages; the bottom of the second carved area is flat and you can use optional and the finer bit because the area is smaller.
Clint
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules