Why has my truck just begin to stop 11.5 inches from the left and 8.5 inches from the right??
Why has my truck just begin to stop 11.5 inches from the left and 8.5 inches from the right??
Measure Twice:Cut once:Cuss Zero
At what point is it doing this?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
We need a little more info... It is possible that your project SCALED because you made the choice to STAY UNDER THE ROLLERS.... and the machine needed 7 inches, 3.5 on each end of the board to stay under the rollers with the size of WOOD you placed in the machine... So it Subtracted 7 inches from your PROJECT making you end project SMALLER or SCALED....
Using a Longer Board or selecting to NOT stay under the Rollers would likely have given you a NORMAL size project BUT when you setup a project that is being held by only ONE roller you can have problems..... Like the board LIFTING into the BIT and making a LINE that is 3.5 inches from the end of the board.... OR if you are doing a Cut Path and the board tilts UP it can SNAP a $40.00 Cutting Bit....
Find Tips and Tricks and read up on Scaling....
This is a WAG..... WILD AL GUESS..... Based on limited information and a hunch....
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
I am fine now. Heat shield loose was hitting the head cover when moving left to right. Thanks for the help. Now I get "please close cover" why I don't know!!!!!!!!!
Measure Twice:Cut once:Cuss Zero
Plugging in the left cover switch wire 180 degrees out can cause it.... white wire toward the center of the machine.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com