I'm also wanting the plastic drive gears on the bottom for the older craftsman model. Would consider buying a complete working machine if the price is right! Thanks, Mike
I'm also wanting the plastic drive gears on the bottom for the older craftsman model. Would consider buying a complete working machine if the price is right! Thanks, Mike
Get A907 upgrade and new x-drive gear assembly.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Do you know if it is possible to just buy the two small circuit boards and the 14 wire FFC to upgrade? Can one do it without buying the z motor? It would be $43 Vs $125.
I don't think so. Where did you get a price for the board on the z motor to come up with $43? Don't think it's sold separately.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
$18 Head Termination Board, $10 FFC, $15 for Z Electronics Board:
http://store.carvewright.com/product...cat=254&page=2
working machine with upgrades 450.00 plus shipping
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!