Results 1 to 9 of 9

Thread: Err eo6 -0303

  1. #1

    Default Err eo6 -0303

    I 'm getting A Z-Axis Stsll Err EO6-0303. Made 7 of the same then started to get this??
    Anyone??

  2. #2
    Join Date
    Aug 2008
    Location
    north ont Canada
    Posts
    2,365

    Default

    check your bearing probably binding
    Henry

    Every one has a photographic memory. Some just don't have film.

  3. #3

    Default

    It goes to 59% then stops

  4. #4
    Join Date
    Sep 2007
    Location
    Northern Colorado
    Posts
    7,962

    Default

    Quote Originally Posted by plaz View Post
    It goes to 59% then stops

    Does it always stop at this place in the carving?

    Try reformatting the card.
    RingNeckBlues
    My patterns on the Depot
    DC-INSERT It Just Sucks!

    Proven to out perform all others!
    Buy CarveWright
    Colorado FaceBook Users Group


    All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.

  5. #5
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    Does anything special happen at 59%? Like, does the carve go deeper or wider?

  6. #6

    Default

    No the error just comes up

  7. #7

    Default

    yes it stops at same place

  8. #8
    Join Date
    Sep 2007
    Location
    Northern Colorado
    Posts
    7,962

    Default

    I would try reformatting the card and refresher the firmware. It you were running the same project back to back the card might of been corrupted.
    RingNeckBlues
    My patterns on the Depot
    DC-INSERT It Just Sucks!

    Proven to out perform all others!
    Buy CarveWright
    Colorado FaceBook Users Group


    All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.

  9. #9
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    Have you tried reformating and reflashing the card? Do you have a DC system? Have you moved the z truck up and down to see if there is a rough spot?

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •