I am running a project with board dimensions 28" long 14.5" wide and .723 thick. When starting it ask me to enter board thickness when I try to enter .723 it will not take it. Does anyone know how to resolve this problem?
I am running a project with board dimensions 28" long 14.5" wide and .723 thick. When starting it ask me to enter board thickness when I try to enter .723 it will not take it. Does anyone know how to resolve this problem?
On your virtual board where you use the board size put .723 thickness.
I did enter .723 as board thickness when setting up the project
Try .725 inches.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Each time I enter .725 it defaults to .727 also when trying to enter in machine when prompted for board thickness I try to enter 0.723 it just gives me 723 instead of .723 also I I try to measure board thickness with machine it does the same thing prompts me to enter board thickness and when I try to enter 0.723 it gives me 723 with no decimal
I believe you can only chose multiples of 1/128". The edit box will round to the nearest 1/128". You type in 0.723 and you get 93/128 = 0.7265625 which rounds t0 0.727 for the display.
I do not know why it will not take the decimal point when I press it on the machine keypad
I just tried it on my machine and it took the 0.723 fine. Do you see the decimal on the display when you press it?
No I do not see it
Sound like a button problem. Just for fun try 93/128.