Need someone to do some modeling for me.

[billybehr]

Hey Guys and Gals,

I need someone to do some very basic modeling for me. I have 1.187 so I don't have the ability to do 3D modeling. I just need a few patterns made and of course am willing to pay. (Not too much though; I still have 5 kids in the house.) I have included all the measurements.

Bill

[bergerud]

Sorry, but it is not clear what you want to do. You can only carve 0.8" deep with 1.187. Do you just want to cut the slots? If so with what bit?

[billybehr]

Sorry, but it is not clear what you want to do. You can only carve 0.8" deep with 1.187. Do you just want to cut the slots? If so with what bit?

Yes, I just want to carve out the recesses and the taper on the top. All of this with the carving bit.

[bergerud]

Here is a quick mpc with the three basic shape I think you want. They were made with extrude and rail sweep. Something to play with.

[billybehr]

Berg,

You are the man. Thank you. You just saved me a whole lot of time on my bandsaw and sanders. What do I owe you my friend?

Bill

[bergerud]

Happy to help. I hope it works out.