Results 1 to 2 of 2

Thread: Y axis stall 299

  1. #1
    Join Date
    Oct 2009
    Location
    Burwell NE
    Posts
    13

    Default Y axis stall 299

    it has done this to me twice. 3\4 through a 3 hour carve. can i save the carving? and why do I get this error the y axis seems to be clean

  2. #2
    Join Date
    Jan 2007
    Location
    NE PA USA
    Posts
    9,984

    Default

    Y Stalls is normally all about the two 685ZZ Roller Bearings in the Gearbox having gone bad..... Recommended to replace them every 250 cut hours.

    Same place twice and it could be a deeper cut and a dull bit....

    AL
    Attached Thumbnails Attached Thumbnails DSC07751_WEB.jpg   DSC07752_WEB.jpg   DSC09644_WEB.jpg   DSC09643_WEB.jpg  

    Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.

    Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074

    www.PoconoDigitalWoodshop.com

    www.AccountabilityTag.com


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •