Still fairly new with the machine (50 hours so far). Haven't learned all the ends and out yet.

Started getting this error during last carving attempt. Day was drier than normal and had a lot of static on the machine with saw dust sticking everywhere. Took the top off and did a thorough cleaning. Checked the y rollers and oiled them. Checked the y gear box and cleaned that out. No visible issues. Manual Y travel smooth without power. loosened the screw to re-tension the y-belt.

And still continue getting the error at the left end of travel right before it is supposed to find the surface. It does a little skip, hits the side of the case and error displays. Not sure what else to try. Anyone else have a suggestion on what to try next.