DON'T USE-Liquid Wrench Chain Lube

[jerrbitt]

Been using Liquid Wrench with Molly since I bought one of the first Compucarve machines many years ago. My bottler is almost gone and I can't find any Liquid Wrench with Molly althogh I have found it with Cerflon.

Is this stuff as good as the original with Molly for use on the flexshaft?

[DocWheeler]

I was just looking to see what I could find and stumbled upon this http://www.amazon.com/Cyclo-C-661-6P...+disulfide+oil
It seems very expensive compared to what I paid for my can of Liquid Wrench Lube years ago.

And, even more costly is http://www.amazon.com/Crown-7043-MOL...+disulfide+oil

This sounds interesting http://www.amazon.com/Bike-Dri-Slide...+disulfide+oil

LHR has something that they recommend on their site.

[chkorte]

What about this?
http://www.globalindustrial.com/p/ja....campaignId=WR

[DocWheeler]

That sounds good, and certainly cheaper than the ones I found.
I wonder if they can be purchased individually?

[fwharris]

From what LHR has said the new formula of liquid wrench does not work for the flex shaft. I would either go with LHR approved lube or CranCam lube with molly http://autoplicity.com/1452128-crane...FciGfgodsRkAbg

[lynnfrwd]

I don't know about all of these suggestions, you guys, but we sell what we have tested. It has molybdenum and graphite in it.

[Signmaker]

Hi,

Can't seem to locate source for chain lube with moly. Carver in storage for years.

Thanks

[fwharris]

Hi,

Can't seem to locate source for chain lube with moly. Carver in storage for years.

Thanks

The LiquidWrench lube formulation was changed a while back so what we had back then is no longer available and the new formulation does not work.

I would go with the CarveWright lube or get some of this http://www.summitracing.com/parts/crn-99002-1

[Smoken D]

Check "Big Lots". I found some a few years ago and took the entire shelf. Cans were $2 each. Might be worth a check if you have one around. It was the Liquid Wrench with Molly. I always had a heating problem with the shaft till I soaked it in this stuff over night. Haven't had a problem since.

[lynnfrwd]

I just renamed this thread. I have had several "discussions" with customers and want to make it CLEAR. They changed their formula and it is NO LONGER EFFECTIVE on the flexshaft.