The centerline text and picture were both within a carved region. I'm assuming that I would also need to leave the carved region intact, less the picture?
The centerline text and picture were both within a carved region. I'm assuming that I would also need to leave the carved region intact, less the picture?
I had a similar problem, so I "aircarved" the region a second time (removing the carving bit after it took the depth measurments ...just before carving started" and then after it air carved the carveout region, I put in the 90 degree vector bit and did the centerline text. I don't know how it would know the depth if you deleted everything about the carveout region and just did the centerline text. Maybe someone on the forum has already solved this problem>
The "work-arounds" are sometimes too obvious to see. I'll surely try it! Should work, thanks.