Can't resolve the problem on this one........need help please

[bergerud]

If this error occurs when the board sensor is measuring the rear edge of the board, try keeping pressure on the end of the board with your hand. Push on the end as it jockeys back and forth determining the edge. That is what I do with mine when I get that error. (I think it might be an x drive backlash thing.)

Edit: you did check the head pressure...right?

[zan29]

I also have this habit of putting a bit of pressure when it's measuring and the head pressure it the only thing I haven't checked so thanks Bergerud for reminding me.

[Digitalwoodshop]

Bergerud makes a good point that I missed... This could actually be a single tooth broken in your X Drive Gears showing up at the Brass Roller....

AL