Originally Posted by
jkbogi
I loaded a new project and during the set up I put in the first bit and all went normal, The bit spun and went through the set up. I switched to the carving bit and it would not spin. I shut down and started over. Again, the first bit spun during the set up and the caving bit would not. I powered the machine down for a minute or so and started again. Now the bit does not spin at all. Any suggestions?
How many hours on that cut motor? Have you checked or changed your carbon brushes?
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!