Having a problem I have not encounter before.
I am carving a military rank plaque with keyholes on the back. Load the back keyholes cut just fine, flip the board and start carving the plaque.
About 4-5 percent into the carving I get an error message to reformat the card and reload the project.
I have reformatted the card and reloaded the project and the same error occurs.
I changed cards - same error
I even actually even started all over with project saved to a different file name and get the same error.
I think I have the problem lies in one of 2 areas - either the Power supply or the controller.
C model machine 28 hours
No issues with my other C model machines. Just this one.