The difference in carving time between "best" and "optimal" is significant (5+ hours vs. 11+ hours). Is there that much difference in quality between the two to justify the difference in carving time?
Dave
The difference in carving time between "best" and "optimal" is significant (5+ hours vs. 11+ hours). Is there that much difference in quality between the two to justify the difference in carving time?
Dave
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
It depends on how much detail is on the design and how much sanding you want to do at the end. On some designs the extra time is not necessary but it can't be judged without seeing the design. There are definitely times when the extra time is justified.
Actually, I'm carving walnut.
I would think walnut would be fine on best.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Last edited by SteveNelson46; 09-30-2014 at 11:27 AM.
Steve
I do 99% of carves on best. I have tried all settings and it works for me.
It's not only 'an opinion' regarding Carve Quality selection. There are real-world benefits.
The amount of bit step over is decreased as you "move up" in the quality choice. if the bit is moving over at only 6% to 8% of the tip diameter with each pass during carving, the longer the carve takes and the higher quality you can expect overall.
The greater the stepover percentage (i.e., lower quality choices make the bit move over more with each pass), the more likely you will see lines and/or ridges in your carvings...and POSSIBLY "fuzzies" too, but fuzzies have more to do with the type of wood, if it's 'good wood' (low moisture, and/or hardwood) and the particular grain direction (whether the bit is carving 'with' or 'against' the grain, etc).
So, contrary to popular belief, the better quality settings are not always a guarantee against 'the fuzzies'. BUT, those settings (BEST and OPTIMAL)most often does reduce sanding time nonetheless.
There is another possible benefit for choosing better quality. Higher quality settings are somewhat "gentler" on your bits and your machine. Try a carving on DRAFT sometime, then run the same one on BEST. You'll see the feed rate is 'crazy fast' on DRAFT, but nice-n-easy going on BEST or OPTIMAL. I think Joe L at CarveWright carves on the NORMAL setting most of the time, and I guess he's pretty happy with that.
EDIT: Some time ago, I did a comparison between stepover settings on my ShopBot and my CarveWright machines. I set the stepover percentages manually for each project on the ShopBot (it's not automatic like the CW). Although far from scientific, I came up with these figures...
DRAFT seems comparable to about 16.6% stepover on the Bot
NORMAL is about 12.5% " " "
BEST is about 8.3% " " "
OPTIMAL is about 6% " " "
Last edited by mtylerfl; 09-30-2014 at 02:15 PM.
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
I do most all mine on OPTIMAL. Rather have the small step over and less sanding. Most times I have a good amount of detail.
What I do other then OPTIMAL is Best. Test carves on normal most times.
Happy Carving
Robert D.
rcdages
CarveWright START U Team Member.
The mightiest oak in the forest is just a little nut
that held it's ground.