Results 1 to 6 of 6

Thread: Edge routing

  1. #1
    Join Date
    Aug 2014
    Location
    Tampa, Fl
    Posts
    68

    Default Edge routing

    My question is, after applying an edge rout to a project and saving it, I wanted to change or remove the applied edge routing. I have yet to figure out how to do it. Any help???

  2. #2
    Join Date
    Feb 2011
    Location
    New Jersey 07748
    Posts
    828

    Default

    Just select it and use the red X to delete it .. or highlite it in the carve list n hit the red X to delete ...
    Mans Quest for knowledge,,, means he'll always find a way !!

  3. #3
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,314

    Default

    Just FYI...edge routing a rectangular or square board is best done with the standalone feature rather than as part of the project. Less chance of mistracking when it comes out from under rollers.
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

  4. #4
    Join Date
    Aug 2014
    Location
    Tampa, Fl
    Posts
    68

    Default

    Thank you....It worked.

  5. #5
    Join Date
    Aug 2014
    Location
    Tampa, Fl
    Posts
    68

    Default

    I prefer to finish project from standalone equipment. That was the reason for removing edge routing from project. The suggestion given my ktjwilliams, worked..

  6. #6
    Join Date
    Nov 2012
    Location
    Galva Kansas
    Posts
    1,005

    Default

    You can also select it, go to the "select bit" menu and just hit the "no bit" button. That removes it from the project too. Just FYI for the future.
    Kansas Wood Shop
    Disabled Veteran owned and operated
    Visit www.kansaswood.com
    A machine with rock, CS machine, Designer 3, centerline, conforming vectors

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •