My question is, after applying an edge rout to a project and saving it, I wanted to change or remove the applied edge routing. I have yet to figure out how to do it. Any help???
My question is, after applying an edge rout to a project and saving it, I wanted to change or remove the applied edge routing. I have yet to figure out how to do it. Any help???
Just select it and use the red X to delete it .. or highlite it in the carve list n hit the red X to delete ...
Mans Quest for knowledge,,, means he'll always find a way !!
Just FYI...edge routing a rectangular or square board is best done with the standalone feature rather than as part of the project. Less chance of mistracking when it comes out from under rollers.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Thank you....It worked.
I prefer to finish project from standalone equipment. That was the reason for removing edge routing from project. The suggestion given my ktjwilliams, worked..
You can also select it, go to the "select bit" menu and just hit the "no bit" button. That removes it from the project too. Just FYI for the future.
Kansas Wood Shop
Disabled Veteran owned and operated
Visit www.kansaswood.com
A machine with rock, CS machine, Designer 3, centerline, conforming vectors