Found this website this morning for bits. Would they work on the CW?
http://www.toolstoday.com/p-6225-sol...uter-bits.aspx
Found this website this morning for bits. Would they work on the CW?
http://www.toolstoday.com/p-6225-sol...uter-bits.aspx
I have bought bits from this site. I think the 46280 and the 46282 are the same as the bits Jeff Bert sells on the Soigeneris site. The 46284 I have bought as an intermediate bit between the normal carving bits and the deep bits. It has a 1.5" depth of cut. It has a 1/8" ball. I have not yet found a good intermediate bit with 1/16" ball and 1.5" depth of cut. Also check out
http://www.carbideprocessors.com/tap...k-vortex-2215/
(Do not buy the 1/16" ball. It is not as pictured and very thin.)
Last edited by bergerud; 04-15-2014 at 08:52 AM.
Thanks for the info ... I am alwayzzzzz on the hunt for bits... 1/16th's are hard to find with a decent length of cut ...
Mans Quest for knowledge,,, means he'll always find a way !!